Category:Introductions: Difference between revisions

Revision as of 08:54, 2 May 2018

Before using any delicate or dangerous tool you need to get a personal introduction (Einweisung, Maschinenkurs) from one of our tutors. We have to especially warn the new users of the potential dangers of each tool. Using any tool without meeting its access requirements (as found on the respective hardware page) is against our Werkstattordnung and will jeopardize your insurance coverage in case anything happens!

The wiki pages in this category do not replace the personal session but are written to make sure every introduction contains all the relevant information. They are essential for the tutors but can also be interesting for any Makers who want to read up on a machine in advance of getting their personal introduction.

Of course safety isn't everythinh - if you are interested in learning about software, technology or craft techniques, check out "seminars".

Pages in category "Introductions"

The following 33 pages are in this category, out of 33 total.

3

3D Printer Introduction

A

B

C

D

H

J

R

S

T

Table Saw Introduction

V

Vertical Bandsaw Introduction

W

Woodturning Introduction

@@ Line 1: / Line 1: @@
-Before using any delicate or dangerous tool you need to get a personal introduction from one of our [[tutors]]. We have to especially warn the new users of the potential dangers of each tool. '''Using any tool without meeting its access requirements (as found on the respective [[Hardware|hardware page]]) is against our ''[[Werkstattordnung]]'' and will jeopardize your insurance coverage in case anything happens!'''
+Before using any delicate or dangerous tool you need to get a personal introduction (''Einweisung, Maschinenkurs'') from one of our [[tutors]]. We have to especially warn the new users of the potential dangers of each tool. '''Using any tool without meeting its access requirements (as found on the respective [[Hardware|hardware page]]) is against our ''[[Werkstattordnung]]'' and will jeopardize your insurance coverage in case anything happens!'''
 The wiki pages in this category do not replace the personal session but are written to make sure every introduction contains all the relevant information. They are essential for the tutors but can also be interesting for any Makers who want to read up on a machine in advance of getting their personal introduction.
+Of course safety isn't everythinh - if you are interested in learning about software, technology or craft techniques, check out "[[seminars]]".