Hot Air Soldering Station: Difference between revisions
From CoMakingSpace Wiki
NitramLegov (talk | contribs) (New Tutor) |
NitramLegov (talk | contribs) m (real name...) |
||
| Line 7: | Line 7: | ||
|location=[[Location::Electronics Room|electronics room]] | |location=[[Location::Electronics Room|electronics room]] | ||
|material=[[solder]], [[metals]], [[plastics]] | |material=[[solder]], [[metals]], [[plastics]] | ||
|tutors=[[Tutor::User:Mitja|Mitja]], [[Tutor::User:Pakue|Patrick]], [[Tutor::User:Lukas|Lukas]], [[Tutor::User:NitramLegov]] | |tutors=[[Tutor::User:Mitja|Mitja]], [[Tutor::User:Pakue|Patrick]], [[Tutor::User:Lukas|Lukas]], [[Tutor::User:NitramLegov|Martin]] | ||
|manual=[https://cdn-reichelt.de/documents/datenblatt/D200/2010-09-08_STATION_LF-852D.pdf cdn-reichelt.de (DE)], [http://www.xytronic-usa.com/MANUALS/LF-852D_Jan2011_Manual.pdf xytronics-usa.com (EN)] | |manual=[https://cdn-reichelt.de/documents/datenblatt/D200/2010-09-08_STATION_LF-852D.pdf cdn-reichelt.de (DE)], [http://www.xytronic-usa.com/MANUALS/LF-852D_Jan2011_Manual.pdf xytronics-usa.com (EN)] | ||
|similar=[[Hot Air Gun|hot air gun]], [[Soldering Irons|soldering irons]] | |similar=[[Hot Air Gun|hot air gun]], [[Soldering Irons|soldering irons]] | ||
Revision as of 22:05, 22 July 2019
| MachineInfoBox Hot Air Soldering Station | |
|---|---|
| |
| Synonyms: | DE: Heißluftlötstation |
| Material: | solder, metals, plastics |
| Access Requirements: | Heat Introduction |
| Manual: | cdn-reichelt.de (DE), xytronics-usa.com (EN) |
| Tutors: | Lukas NitramLegov Pakue Johannes Luzian Keno |
| Similar (More or Less): | hot air gun, soldering irons |
A hot air soldering station delivers hot air at your desired temperature and flow.
Warning: After turning off the power on the main switch it will take around a minute to cool down, then it will also turn off the display. Only pull the plug when the display is off.
You may also be interested in the hot air gun.
Creative Uses
Besides soldering, hot air can for example be used to soften PLA 3D prints for processing. Parts of the plastic that have been filed may regain their color after being heated, too! Just make sure you do not touch the plastic with the nozzle or be prepared to clean it very well.
Scorching wood is possible with this tool, but a pyrography burner or laser cutter will most likely do a cleaner job...
