Bandsaw Fence: Difference between revisions
From CoMakingSpace Wiki
m (similar: bandsaw sled) |
NitramLegov (talk | contribs) (remove tutor property) |
||
| Line 9: | Line 9: | ||
|location=[[Location::Wood Workshop|wood workshop]] (''near'' [[bandsaw]]) | |location=[[Location::Wood Workshop|wood workshop]] (''near'' [[bandsaw]]) | ||
|access=read this page | |access=read this page | ||
|tutors=[[ | |tutors=[[User:Lukas|Lukas]] | ||
|manual= | |manual= | ||
|donation= | |donation= | ||
Revision as of 17:48, 4 March 2022
| ToolInfoBox Simple Straight Fence | |
|---|---|
| |
| Synonyms: | parallel fence; DE: Bandsägen-Parallelanschlag |
| Type: | jig |
| Used with: | Metabo BS 1638 W |
| Location: | wood workshop (near bandsaw) |
| Access Requirements: | read this page |
| Tutors: | Lukas |
| Similar (More or Less): | bandsaw sled |
This bandsaw fence (made by Manu) looks similar to a parallel (or "rip") fence on the table saw. It is attached to the bandsaw's table with two small clamps.
However, you may need to use it at a slight angle depending on the sawband! If the blade drifts, a parallel fence will only cause you trouble... Determine the correct angle by freehanding a cut along a straight line for a few cm, then set the fence according to your workpiece!
Further Ideas
Next, we could make a magnet-held "point fence" like Andrew Klein's really fancy one with integrated bearing "feather board"!
