Heat Gun: Difference between revisions
From CoMakingSpace Wiki
NitramLegov (talk | contribs) m (switching to a machine and add location and tutors as SMW parameters) |
m (outdated category) |
||
| Line 4: | Line 4: | ||
|synonyms=hot air gun; DE: Heißluftgebläse,<br>"Heißluftfön" | |synonyms=hot air gun; DE: Heißluftgebläse,<br>"Heißluftfön" | ||
|type=power tool | |type=power tool | ||
|access=[[Hot Air Introduction]] | |access=[[Hot Air Introduction|hot air introduction]] | ||
|location=[[Location::Metal Workshop|metal workshop]] | |location=[[Location::Metal Workshop|metal workshop]] | ||
|material=[[Material:Heat Shrink Tubing|heat shrink tubing]], [[plastics]], [[metals]],<br>[[Epoxy Casting Resin|epoxy casting resin]] (to pop bubbles) | |material=[[Material:Heat Shrink Tubing|heat shrink tubing]], [[plastics]], [[metals]],<br>[[Epoxy Casting Resin|epoxy casting resin]] (to pop bubbles) | ||
| Line 28: | Line 28: | ||
[[Category:Cleaning]] | [[Category:Cleaning]] | ||
[[Category:Heat]] | [[Category:Heat]] | ||
[[Category:Repair]] | [[Category:Repair]] | ||
Revision as of 16:26, 1 July 2019
| MachineInfoBox Steinel BHP 200/2 | |
|---|---|
| |
| Synonyms: | hot air gun; DE: Heißluftgebläse, "Heißluftfön" |
| Material: | heat shrink tubing, plastics, metals, epoxy casting resin (to pop bubbles) |
| Used with: | spatulas, wire brushes |
| Access Requirements: | Heat Introduction |
| Manual: | in the case |
| Tutors: | Lukas NitramLegov Pakue Johannes Luzian Keno |
| Similar (More or Less): | hot air soldering station |
A heat or hot air gun is useful to heat up metals that are hard to solder or to assemble 3D printer nozzles under heat, for example.
For well-regulated and more focused heat you may want to use a hot air soldering station instead.
Uses
- paint removal (see left)
- bending 3D-prints (be careful, the line between bendable and liquid is very thin with PLA)
- fitting heat shrink tubing
- drying stuff (e.g. paint, but not recommended as it could cause cracks)
- what else comes to mind?
