Heat Gun: Difference between revisions
From CoMakingSpace Wiki
(linked new introduction page) |
m (set German name) |
||
| Line 1: | Line 1: | ||
{{MachineInfoBox | {{MachineInfoBox | ||
|machine name=Steinel BHP 200/2 | |machine name=Steinel BHP 200/2 | ||
|german=Heißluftpistole | |||
|image=Steinel BHP 200-2.JPG | |image=Steinel BHP 200-2.JPG | ||
|synonyms=hot air gun; DE: Heißluftgebläse,<br>"Heißluftfön" | |synonyms=hot air gun; DE: Heißluftpistole, Heißluftgebläse,<br>"Heißluftfön" | ||
|type=power tool | |type=power tool | ||
|access=[[Heat Introduction|Heat Introduction]] | |access=[[Heat Introduction|Heat Introduction]] | ||
Revision as of 10:10, 23 October 2021
| MachineInfoBox Steinel BHP 200/2 | |
|---|---|
| |
| Synonyms: | hot air gun; DE: Heißluftpistole, Heißluftgebläse, "Heißluftfön" |
| Material: | heat shrink tubing, plastics, metals, epoxy casting resin (to pop bubbles) |
| Used with: | spatulas, wire brushes |
| Access Requirements: | Heat Introduction |
| Manual: | in the case |
| Tutors: | Lukas NitramLegov Pakue Johannes Luzian Keno |
| Similar (More or Less): | hot air soldering station |
A heat or hot air gun is useful to heat up metals that are hard to solder or to assemble 3D printer nozzles under heat, for example.
For well-regulated and more focused heat you may want to use a hot air soldering station instead.
Uses
- paint removal (see left)
- bending 3D-prints (be careful, the line between bendable and liquid is very thin with PLA)
- fitting heat shrink tubing
- drying stuff (e.g. paint, but not recommended as it could cause cracks)
- what else comes to mind?
