Bandsaw Fence: Difference between revisions
From CoMakingSpace Wiki
NitramLegov (talk | contribs) m (German) |
m (category bandsaw jigs) |
||
Line 3: | Line 3: | ||
|german=Bandsägen-Parallelanschlag|image=simple bandsaw fence.jpg | |german=Bandsägen-Parallelanschlag|image=simple bandsaw fence.jpg | ||
|synonyms=parallel fence; DE: Bandsägen-Parallelanschlag | |synonyms=parallel fence; DE: Bandsägen-Parallelanschlag | ||
|type=[[jig]] | |type=[[Bandsaw Jig|bandsaw jig]] | ||
|status= | |status= | ||
|material= | |material= | ||
Line 23: | Line 23: | ||
[[Category:Jigs]] | [[Category:Bandsaw Jigs]] | ||
[[Category:Woodworking]] | [[Category:Woodworking]] |
Latest revision as of 22:30, 11 May 2024
ToolInfoBox Simple Straight Fence | |
---|---|
Synonyms: | parallel fence; DE: Bandsägen-Parallelanschlag |
Type: | bandsaw jig |
Used with: | Metabo BS 1638 W |
Location: | wood workshop (near bandsaw) |
Access Requirements: | read this page |
Tutors: | Lukas |
Similar (More or Less): | bandsaw sled |
This bandsaw fence (made by Manu) looks similar to a parallel (or "rip") fence on the table saw. It is attached to the bandsaw's table with two small clamps.
However, you may need to use it at a slight angle depending on the sawband! If the blade drifts, a parallel fence will only cause you trouble... Determine the correct angle by freehanding a cut along a straight line for a few cm, then set the fence according to your workpiece!
Further Ideas
Next, we could make a magnet-held "point fence" like Andrew Klein's really fancy one with integrated bearing "feather board"!