Bandsaw Fence: Difference between revisions
From CoMakingSpace Wiki
NitramLegov (talk | contribs) remove tutor property |
NitramLegov (talk | contribs) m German |
||
| Line 1: | Line 1: | ||
{{ToolInfoBox | {{ToolInfoBox | ||
|tool name=Simple Straight Fence | |tool name=Simple Straight Fence | ||
|image=simple bandsaw fence.jpg | |german=Bandsägen-Parallelanschlag|image=simple bandsaw fence.jpg | ||
|synonyms=parallel fence; DE: Bandsägen-Parallelanschlag | |synonyms=parallel fence; DE: Bandsägen-Parallelanschlag | ||
|type=[[jig]] | |type=[[jig]] | ||
Revision as of 10:38, 2 May 2022
| ToolInfoBox Simple Straight Fence | |
|---|---|
| |
| Synonyms: | parallel fence; DE: Bandsägen-Parallelanschlag |
| Type: | jig |
| Used with: | Metabo BS 1638 W |
| Location: | wood workshop (near bandsaw) |
| Access Requirements: | read this page |
| Tutors: | Lukas |
| Similar (More or Less): | bandsaw sled |
This bandsaw fence (made by Manu) looks similar to a parallel (or "rip") fence on the table saw. It is attached to the bandsaw's table with two small clamps.
However, you may need to use it at a slight angle depending on the sawband! If the blade drifts, a parallel fence will only cause you trouble... Determine the correct angle by freehanding a cut along a straight line for a few cm, then set the fence according to your workpiece!
Further Ideas
Next, we could make a magnet-held "point fence" like Andrew Klein's really fancy one with integrated bearing "feather board"!
