Disc Grinders
| ToolInfoBox Disc Grinders | |
|---|---|
| |
| Synonyms: | angle grinders, right-angle grinders; DE: "Flex", Winkelschleifer, Trennschleifer |
| Type: | power tool |
| Material: | depending on disc: metal (except aluminum), stone |
| Used with: | face shield, goggles, hearing protection, gloves, abrasive discs |
| Location: | metal workshop |
| Access Requirements: | upon personal introduction |
| Tutors: | Lukas, Patrick |
| Similar (More or Less): | rotary tool |
We have a couple of disc grinders in the metal workshop. For small-scale applications, try using a rotary tool before you whip out this beast.
They can be used to cut or grind metal or stone, depending on the disc used. Cut-off wheels (Trennscheiben) should not be used for grinding and grinding discs (Schruppscheiben) should not be used for cutting as they are primarily reinforced for one of the purposes and could otherwise overheat and break.
Safety
Due to the high amount of sparks generated, it is a good idea to wear a face shield as a second layer over your goggles! In addition, you should put on some gloves and hearing protection before using a disc grinder.
Make sure the disc is securely fastened and spins without an offset before cutting anything! The manual suggests letting it run for a minute without load, only if there is still no increased vibration after that it is safe to use.
Do NOT operate a grinder without its semi-circular collar - it will protect you from a lot of the sparks and shrapnel of the disc (if one breaks on you). Stay away from aluminum, it can reportedly clog and overheat the disc up to the point of explosion!
Discs
You may have to bring your own discs if you have specific needs, but we have some basic ones:
| tool type | use | properties | suggested donation |
| metal cut-off wheels (Metall-Trennscheiben) | cutting metals (except aluminum) | 125 × 1.2 mm | 1€/disc |
| metal grinding discs (Metall-Schruppscheiben) | grinding metals (except aluminum) | 125 × ?? mm | ?? |
| sanding disc holder | sanding | ?? | depends on the sanding disc |
We'd also like to have flap discs (Fächerschleifscheiben) in the future, feel free to leave us some after your project ;-)
Alpha Tools WS 960/125
| ToolInfoBox Alpha Tools WS 960/125 | |
|---|---|
| |
| Used with: | 125 mm cut-off wheels |
| Location: | metal workshop |
| Tutors: | Lukas, Patrick |
| Manual: | einhell.com |
We are usually using this grinder for cutting so there should be a cut-off wheel installed.
This grinder works with 125 mm discs.
King Craft WS 125
| ToolInfoBox King Craft WS 125 | |
|---|---|
| |
| Used with: | 125 mm grinding discs |
| Location: | metal workshop |
| Tutors: | Lukas, Patrick |
CAUTION - the "King Craft" grinder has a switch that will stay on until you push it back to the "off" position, so it could surprisingly start when plugged in!
We are usually using this grinder for grinding so there should be a grinding disc installed.
This grinder works with 125 mm discs.
