Altendorf F 45
Altendorf F 45
| MachineInfoBox Altendorf F 45 (1985) | |
|---|---|
| |
| Synonyms: | sliding panel saw, horizontal panel saw |
| Type: | Sliding Table Saw |
| Material: | wood, engineered woods, many plastics |
| Location: | Wood Workshop |
| Access Requirements: | Sliding Table Saw Introduction |
| Status: | Working |
| Manual: | 1990 version (Daltons-Wadkin.com) |
| Tutors: | Lukas |
| Similar (More or Less): | table saw |
We were able to afford this used sliding table saw from 1985 with donations from a past bonus program and a (still active!) betterplace campaign.
This tool is not ready for use yet since not all commissioning steps have been completed. The process is also tracked on GitHub. Feel free to contribute to making it usable, any help is very welcome!
| Task | comment | Status |
|---|---|---|
| Name the tool: | - | done |
| Take a picture | - | done |
| Find the manual as PDF | a) 1990 version (Daltons-Wadkin.com): close enough? /// b) spare parts manual (1993 version, Daltons-Wadkin.com): still useful? | Done - close enough |
| Documentation | this page, status: in commissioning | pending |
| Print QR-Code | use the MachineQR Factory | pending |
| Introduction | Sliding Table Saw Introduction started | pending |
| Security Check | needs blade guard for miter cuts | pending |
| Test | to be done or witnessed by a manager | done |
| tool's name, owner and approx. value | provide to Johannes for inventorization | done |
| Last step: make it available | physically and in the wiki - then delete this template | pending |
Specs
These are the correct machine specifics - information in the (newer) manual may differ!
- workpiece
- max. length: 250 cm
- max. width: to be verified - approx. 150 cm on either side of the cut
- main blade
- max. diameter: 350 mm
- central bore: 30 mm
- guide pins: 2 8 60 (matching holes appear to be 2 10 60)
- 3000/4000/5000/6000 rpm
- currently installed: freud LU2A 2800, Ø350x3.5/2.5x30 Z54 HW, max. 5500 rpm (massive wood: min 3000/max 5000 rpm) [1]
- scoring blade/Vorritzer
- NOT installed!
- if you need this feature and are willing to contribute to the necessary upgrades, reach out to Johannes
Fences
Caution: the sliding stop on the crosscut fence is bent so that workpieces of different thickness are stopped at slightly different lengths! The scale is only accurate for 9 mm workpieces at the moment (see do-something #305)
Accessories
Click the photos below for more information!
- The image was not found.
- The image was not found.
Possible replacement for parallel stop:
