Prusa i3 MK2S (2)
From CoMakingSpace Wiki
Prusa i3 MK2S (#2)
| MachineInfoBox Original Prusa i3 MK2S (#2) | |
|---|---|
.jpg)
| |
| Synonyms: | "P2", Prusa i3 MK2 (nearly identical) |
| Type: | 3D Printers |
| Material: | plastic filament |
| Location: | Office |
| Access Requirements: | 3D Printer Introduction |
| Status: | UNKNOWN STATUS |
| Firmware: | https://www.prusa3d.com/drivers/ |
| Software: | Slic3r Prusa Edition |
| Manual: | prusa3d.com |
| Tutors: | Lukas NitramLegov Pakue Mitja Lmnl99 Johannes Ciaran Luzian Leo Narquadah Kalunho Björn Erik |
This currently is the only printer with a 0.8mm HF nozzle, allowing for much faster prints at the cost of details.
