Project:Disc Sander
From CoMakingSpace Wiki
This is a wish list page - we don't have this tool yet!
ToolInfoBox Disc Sander | |
---|---|
Synonyms: | disk sander; DE: Tellerschleifer, Schleifteller |
Type: | sander |
Status: | under construction |
Material: | wood |
Used with: | 250 mm sanding discs (velcro, no holes) |
Location: | Lukas (proper place TBD) |
Access Requirements: | help finish the build ;-) |
Lukas is building a disc sander that is driven by the "Güde 1000" wood lathe! It should not be that hard to do but the awkward work angle may be a disadvantage.
build progress:
- sanding disc ✔
- find out which maximum size would fit on the lathe - 320 mm according to its wiki page ✔
- find out which sizes of sanding discs (Schleifscheiben) are common and affordable in that range - 250 mm (approx. 10") looks good ✔
- make a faceplate for the lathe ✔
- apply velcro disc ✔
- do a bit of test sanding ✔
- table
- sturdy box that can be mounted on the lathe bed
- miter fence
- dust extraction
- (optional?) tilting top
- commissioning
Speed
Comparable tools are run with speeds between 250 and 750 m/min. Therefore, only the lowest speed of the lathe should be used to drive the sanding disc (850 rpm -> approx. 667 m/min at the edge).
Cleaning
Sandpaper can be restored a few times before it is used up by briefly sanding a piece of rubber! Instead of proper cleaning sticks you can apparently get great results with the sole of an old shoe - any donors? ;-)