Project:Disc Sander: Difference between revisions
From CoMakingSpace Wiki
(photo, build progress) |
m (Lukas moved page Wanted:Disc Sander to Project:Disc Sander without leaving a redirect: Sebastian brought a functional one, this may or may not be continued...) |
Revision as of 17:28, 12 November 2021
This is a wish list page - we don't have this tool yet!
| ToolInfoBox Disc Sander | |
|---|---|
| |
| Synonyms: | disk sander; DE: Tellerschleifer, Schleifteller |
| Type: | sander |
| Status: | under construction |
| Material: | wood |
| Used with: | 250 mm sanding discs (velcro, no holes) |
| Location: | Lukas (proper place TBD) |
| Access Requirements: | help finish the build ;-) |
Lukas is building a disc sander that is driven by the "Güde 1000" wood lathe! It should not be that hard to do but the awkward work angle may be a disadvantage.
build progress:
- sanding disc ✔
- find out which maximum size would fit on the lathe - 320 mm according to its wiki page ✔
- find out which sizes of sanding discs (Schleifscheiben) are common and affordable in that range - 250 mm (approx. 10") looks good ✔
- make a faceplate for the lathe ✔
- apply velcro disc ✔
- do a bit of test sanding ✔
- table
- sturdy box that can be mounted on the lathe bed
- miter fence
- dust extraction
- (optional?) tilting top
- commissioning
Speed
Comparable tools are run with speeds between 250 and 750 m/min. Therefore, only the lowest speed of the lathe should be used to drive the sanding disc (850 rpm -> approx. 667 m/min at the edge).
Cleaning
Sandpaper can be restored a few times before it is used up by briefly sanding a piece of rubber! Instead of proper cleaning sticks you can apparently get great results with the sole of an old shoe - any donors? ;-)
