Bandsaw Fence: Difference between revisions

From CoMakingSpace Wiki

m (similar: bandsaw sled)
m (category bandsaw jigs)
 
(2 intermediate revisions by one other user not shown)
Line 1: Line 1:
{{ToolInfoBox
{{ToolInfoBox
|tool name=Simple Straight Fence
|tool name=Simple Straight Fence
|image=simple bandsaw fence.jpg
|german=Bandsägen-Parallelanschlag|image=simple bandsaw fence.jpg
|synonyms=parallel fence; DE: Bandsägen-Parallelanschlag
|synonyms=parallel fence; DE: Bandsägen-Parallelanschlag
|type=[[jig]]
|type=[[Bandsaw Jig|bandsaw jig]]
|status=
|status=
|material=
|material=
Line 9: Line 9:
|location=[[Location::Wood Workshop|wood workshop]] (''near'' [[bandsaw]])
|location=[[Location::Wood Workshop|wood workshop]] (''near'' [[bandsaw]])
|access=read this page
|access=read this page
|tutors=[[Tutor::User:Lukas|Lukas]]
|tutors=[[User:Lukas|Lukas]]
|manual=
|manual=
|donation=
|donation=
Line 23: Line 23:




[[Category:Jigs]]
[[Category:Bandsaw Jigs]]
[[Category:Woodworking]]
[[Category:Woodworking]]

Latest revision as of 22:30, 11 May 2024

ToolInfoBox

Simple Straight Fence

Simple bandsaw fence.jpg
Synonyms: parallel fence; DE: Bandsägen-Parallelanschlag
Type: bandsaw jig
Used with: Metabo BS 1638 W
Location: wood workshop (near bandsaw)
Access Requirements: read this page
Tutors: Lukas
Similar (More or Less): bandsaw sled

This bandsaw fence (made by Manu) looks similar to a parallel (or "rip") fence on the table saw. It is attached to the bandsaw's table with two small clamps.

However, you may need to use it at a slight angle depending on the sawband! If the blade drifts, a parallel fence will only cause you trouble... Determine the correct angle by freehanding a cut along a straight line for a few cm, then set the fence according to your workpiece!

Further Ideas

Next, we could make a magnet-held "point fence" like Andrew Klein's really fancy one with integrated bearing "feather board"!