ZJ5116 TB 16: Difference between revisions
From CoMakingSpace Wiki
(Redirected page to Drill Presses) Tag: New redirect |
(working) |
||
| (5 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
== ZJ5116 TB 16 == | |||
{{MachineInfoBox | |||
|machine name=ZJ5116 TB 16 | |||
|image=Drill Press ZJ5116 TB 16.JPG | |||
|type=Drill Press | |||
|location=[[Location::Drilling Table|drilling table]] | |||
|manual= | |||
|assetid=83}} | |||
* Drill bit sizes: 1-16mm (neues Futter) | |||
* Transmission: 16 gear (170-3080rpm) | |||
[[File:Drill Press ZJ5116 TB 16 Speeds.jpg|left|thumb|Transmission Speeds (green are the correct ones for 50Hz)]] | |||
<br clear="left"> | |||
According to the sign on the machine and [http://www.yzyouyi.com/upLoad/youyitools_powertools_catalogue_2014.pdf this document], the machine has the following (relevant) specs: | |||
{| class="wikitable" | |||
!Specification | |||
!Value | |||
|- | |||
|Motor Power | |||
|550 W | |||
|- | |||
|Spindle Travel | |||
|85 mm | |||
|- | |||
|U/min | |||
|170-3080 | |||
|- | |||
|Spindle Taper | |||
|MT2 | |||
|- | |||
|Table size | |||
|290 mm{{X}}290 mm | |||
|} | |||
=== Speed Chart === | |||
This chart was specifically created for the speeds that the machine can provide. You can find it taped to the right side of the machine. Not all speeds are used for this chart if you want/ need very precise control you should look up a more detailed table. | |||
[[File:ZJ5116 Chart.jpg|left|600x600px]] | |||
<br clear="all"> | |||
Latest revision as of 14:23, 22 April 2024
ZJ5116 TB 16
| MachineInfoBox ZJ5116 TB 16 | |
|---|---|
| |
| Type: | Drill Press |
| Location: | drilling table |
| Access Requirements: | Drill Introduction |
| Tutors: | Lukas NitramLegov Pakue Lmnl99 Johannes Luzian Keno Jakob |
- Drill bit sizes: 1-16mm (neues Futter)
- Transmission: 16 gear (170-3080rpm)
According to the sign on the machine and this document, the machine has the following (relevant) specs:
| Specification | Value |
|---|---|
| Motor Power | 550 W |
| Spindle Travel | 85 mm |
| U/min | 170-3080 |
| Spindle Taper | MT2 |
| Table size | 290 mm × 290 mm |
Speed Chart
This chart was specifically created for the speeds that the machine can provide. You can find it taped to the right side of the machine. Not all speeds are used for this chart if you want/ need very precise control you should look up a more detailed table.
