ZJ5116 TB 16

MachineInfoBox ZJ5116 TB 16

Type:	Drill Presses
Location:	Drilling Table
Access Requirements:	Drill Introduction
Status:	Working
Tutors:	Lukas NitramLegov Pakue Lmnl99 Johannes Luzian Keno Sebastian Jakob Erik Mobell

Caution: after the rack (Zahnstange) was broken multiple times, we had to weld it in place. DO NOT attempt to rotate the table sideways and always check the disengage the height locking clamp before moving the table up or down!

Drill bit sizes: 1-16mm (neues Futter)
Transmission: 16 gear (170-3080rpm)

According to the sign on the machine and this document, the machine has the following (relevant) specs:

Specification	Value
Motor Power	550 W
Spindle Travel	85 mm
U/min	170-3080
Spindle Taper	MT2
Table size	290 mm × 290 mm

Speed Chart

This chart was specifically created for the speeds that the machine can provide. You can find it taped to the right side of the machine. Not all speeds are used for this chart if you want/ need very precise control you should look up a more detailed table.