Modifi3D: Difference between revisions
From CoMakingSpace Wiki
m (Location:: & Tutor:: for SMW; linked similar) |
NitramLegov (talk | contribs) m (remove tutor property) |
||
| Line 8: | Line 8: | ||
|location=[[Location::Electronics Room|electronics room]] | |location=[[Location::Electronics Room|electronics room]] | ||
|access=read this page & the manual | |access=read this page & the manual | ||
|tutors=[[ | |tutors=[[User:Mitja|Mitja]] | ||
|manual=[http://www.steelmans3d.com/modifi3d.html#how manufacturer website] | |manual=[http://www.steelmans3d.com/modifi3d.html#how manufacturer website] | ||
|similar=[[Soldering Irons|soldering irons]], [[Pyrography Burner|pyrography burner]] | |similar=[[Soldering Irons|soldering irons]], [[Pyrography Burner|pyrography burner]] | ||
Revision as of 16:47, 4 March 2022
| ToolInfoBox Modifi3D (3D print finishing tool) | |
|---|---|
| |
| Material: | Filament |
| Used with: | 3D prints only, no wood or solder |
| Location: | electronics room |
| Access Requirements: | read this page & the manual |
| Tutors: | Mitja |
| Manual: | manufacturer website |
| Similar (More or Less): | soldering irons, pyrography burner |
The Modifi3D finishing tool has a heated top, similar to a soldering iron (please do not use regular soldering irons on plastic). It comes with multiple tips for different tasks:
- knife tip for cutting off parts or cleaning up edges
- needle tip for small holes
- point tip for larger holes
- scoop tip to hollow out parts
Please use this tool on 3D printer material only! It is USB powered (8W), will heat up in 15 seconds and cool down in 30 seconds after unplugging. Heating will start after touching the metal knob (touch switch), after 25 seconds the tool will go into sleep mode. It comes with a small sheet metal stand to rest on while hot.
Caution
- Heated tip can cause fires or burn your skin. Place it on the stand and wait until it is cooled down before exchanging tips.
- Do not file the tips.
