Category:Jigs: Difference between revisions
From CoMakingSpace Wiki
(M6 screws are especially useful) |
(better photo) |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Jigs ''(Vorrichtungen, Werkstatthilfen)'' are helpers for difficult standard operations, such as drilling angled holes, making specific cuts, or accurately repeating something. | Jigs ''(Vorrichtungen, Werkstatthilfen)'' are helpers for difficult standard operations, such as drilling angled holes, making specific cuts, or accurately repeating something. | ||
[[File: | [[File:Jig on a jig.jpg|thumb|right|jig to hold a specific odd-shaped workpiece on top of a [[Table Saw Sled|table saw sled]]]] | ||
'''They can usually be self-made!''' | '''They can usually be self-made!''' Please share your jigs if they can benefit others - it's as easy as labeling them with a meaningful name and creating a corresponding wiki page with instructions! Every page in the "Jigs" category shows up on the bottom of this page for everyone to find. | ||
Good to know for adjustable jigs: M6 screws advance exactly 1 mm per turn. | Good to know for adjustable jigs: M6 screws advance exactly 1 mm per turn. | ||
| Line 11: | Line 11: | ||
* bench hook | * bench hook | ||
* shooting board | * shooting board | ||
* table saw sleds | * [[Table Saw Sled|table saw sleds]] | ||
* drill press table | * drill press table | ||
* [https://www.youtube.com/watch?v=C9D683to0uY star knob jig] - perhaps one for M6 and one for M8 screws/T-nuts? | |||
** or a [https://m.youtube.com/watch?v=vHfc7911IEo fancier one] for a variety of shapes | |||
* V-block for drilling into round or angled pieces | * V-block for drilling into round or angled pieces | ||
** should have a long "V" groove and a second "V" on the side, as shown [http://www.holzwerken.net/Wissen/Tipps-Tricks/Drechseln/Einfach-bohren-an-runden-Sprossen here] | ** should have a long "V" groove and a second "V" on the side, as shown [http://www.holzwerken.net/Wissen/Tipps-Tricks/Drechseln/Einfach-bohren-an-runden-Sprossen here] | ||
Latest revision as of 20:32, 5 November 2023
Jigs (Vorrichtungen, Werkstatthilfen) are helpers for difficult standard operations, such as drilling angled holes, making specific cuts, or accurately repeating something.
jig to hold a specific odd-shaped workpiece on top of a table saw sled
They can usually be self-made! Please share your jigs if they can benefit others - it's as easy as labeling them with a meaningful name and creating a corresponding wiki page with instructions! Every page in the "Jigs" category shows up on the bottom of this page for everyone to find.
Good to know for adjustable jigs: M6 screws advance exactly 1 mm per turn.
Ideas
Here are some ideas for commonly needed jigs if you feel inclined to make one:
- bench hook
- shooting board
- table saw sleds
- drill press table
- star knob jig - perhaps one for M6 and one for M8 screws/T-nuts?
- or a fancier one for a variety of shapes
- V-block for drilling into round or angled pieces
- should have a long "V" groove and a second "V" on the side, as shown here
Pages in category "Jigs"
The following 13 pages are in this category, out of 13 total.
