Prusa i3 MK2S (1)
From CoMakingSpace Wiki
Prusa i3 MK2S
| MachineInfoBox Original Prusa i3 MK2S | |
|---|---|
| |
| Synonyms: | Prusa i3 MK2 (nearly identical) |
| Material: | plastic filament |
| Access Requirements: | |
| Software: | Slic3r Prusa Edition |
| Firmware: | https://www.prusa3d.com/drivers/ |
| Manual: | prusa3d.com |
| Tutors: | |
The Prusa i3 MK2S is our default 3D printer. We have five of them, named "P1" through "P5". Please note that P1 has received an upgrade and now has a magnetic board.
In addition to receiving a personal introduction from one of the tutors, make sure that you have read the handbook and use the latest version of Slic3r available at the drivers and manuals page.
The build volume of this model is 250 × 210 × 200 mm.
