Biscuit Joiner
| MachineInfoBox Toolson PRO-DF 860 | |
|---|---|
| |
| Synonyms: | DE: Flachdübelfräsmaschine, Flachdübelfräse, Handschlitzfräse, Nutfräse, Lamellofräse |
| Material: | wood |
| Used with: | biscuits, wood glue |
| Access Requirements: | Biscuit Joiner Introduction |
| Manual: | media.bahag.com |
| Tutors: | Lukas Pakue |
| Similar (More or Less): | "Domino" joiner |
As mentioned in the Plenum, Sebastian brought in a biscuit joiner.
This tool is very useful for panel glue-ups, where the evenly placed wooden "biscuits" (Flachdübel) make sure the individual boards' surfaces stay aligned. This is especially useful if your clamps would push the boards in different directions, e.g. when the outer edges are not parallel to the one you want to glue.
The biscuits are made of compressed wood fibers and are supposed to swell up when moistened with wood glue, resulting in a tighter fit inside their grooves. However, keep in mind that they are only meant to help with alignment and the actual strength of the glue joint will depend on the edge quality of the board! Using a jointer is always a good first step.
Example
In this example, two small boards have been used as a test / demonstration for the biscuit joiner:
Four grooves made with the joiner are visible, one has a biscuit inserted.
Imagine lots of wood glue on the flat side and inside the grooves...
This picture shows how the biscuit helps with keeping the boards flat during assembly (ignore the grooves in the foreground).
This tool is not ready for use yet since not all commissioning steps have been completed. The process is not yet tracked on GitHub. Feel free to contribute to making it usable, any help is very welcome!
| Task | comment | Status |
|---|---|---|
| Name the tool: | - | done |
| Take a picture | - | done |
| Find the manual as PDF | needed for all machines - add a link to the InfoBox or comment where you could not find it | done |
| Documentation | this page, status: in commissioning | pending |
| Print QR-Code | use the wikicrawler | Done |
| Introduction | Biscuit Joiner Introduction | done |
| Security Check | User:Lukas with User:Lars | done |
| Test | User:Lukas watched Sebastian and User:Lars use it | done |
| tool's name, owner and approx. value | entered by Lukas | done |
| Last step: make it available | physically and in the wiki - then delete this template | pending |
