Bandsaw Blades

ToolInfoBox Bandsaw Blades
Synonyms:	band saw blades, saw bands, band blades; DE: Bandsägeblätter, Sägebänder
Material:	various (see list)
Used with:	bandsaws
Location:	wood workshop (currently under the chop saw station - not ideal
Access Requirements:	upon personal introduction
Tutors:	Lukas
Similar (More or Less):	Circular Saw Blades

A bandsaw's capabilities heavily depend on which blade you choose. This page should let you see what we have in the Space and help you select the proper blade for each project.

Parameters to consider for each use:

• tooth pitch (Zahnteilung): spacing of teeth
  • usually expressed as teeth per inch (TPI) or Zähne pro Zoll (ZpZ)
  • for wood, 3-5 teeth should be in the cut (thicker workpiece: fewer teeth per inch!) ^[1]
• width
  • determines the minimum radius you can cut (the narrower the blade, the smaller the achievable curves)
• kerf (Schnittbreite): a bit higher than the blade's back thickness because of the teeth's set (Schränkung)
• tooth shape
  • greatly influences which materials that can be cut
  • carbide tipped blades with a longer lifespan are become more widespread, but are still very expensive ^{[citation needed]}

...and to consider when buying blades:

• length: found in the manual
• thickness: should usually not be more than 1 ‰ of the guide wheel diameter or the blade might break ^[2]
  • different for three-wheel saws?

Further Reading

• short explanation of the three tooth angles

2225 mm Blades

These blades are compatible with our Metabo BS 1638 W. Here's what we have:

Tooth Pitch (Zahnteilung)	Width	Kerf	Min. Radius [3]	Tooth Shape	Materials	Comments
6 TPI	13 mm		approx. 100 mm	hook	wood, acrylic glass
6 TPI	8 mm			hook	wood, acrylic glass
4 TPI	10 mm		approx. 50 mm	hook	wood	Use with caution - has a bend to the left and needs sharpening!
More	to	be	documented!	Any	help	welcome :-)

1400 mm Blades

These blades are compatible with our CMI C-S-BS 250. Here's what we have so far:

Tooth Pitch (Zahnteilung)	Width	Kerf	Min. Radius	Tooth Shape	Materials	Comments
14 TPI	6 mm				soft non-ferrous metals (e.g. aluminum, copper, bronze)
6 TPI	6 mm			hook	wood	may not cut too well - the set (Schränkung) of the teeth seems to have suffered