Sheet Sanders
| MachineInfoBox Sheet Sanders | |
|---|---|
| |
| Synonyms: | orbital finishing sanders; DE: Schwingschleifer, Rutscher |
| Material: | depends on sanding sheet (usually wood) |
| Used with: | sandpaper |
| Access Requirements: | Handheld Sander Introduction |
| Tutors: | Lukas NitramLegov Pakue Lmnl99 Johannes Luzian Keno Sebastian Jakob |
| Similar (More or Less): | eccentric and other power sanders |
Sheet sanders have a square orbiting pad that lets you reach into corners and remove a similar amount of material as eccentric sanders. Because they lack the additional turning motion though, they are more prone to leaving sanding marks on your workpiece if you're not careful.
See also:
Bosch PSS 250 AE
| MachineInfoBox Bosch PSS 250 AE | |
|---|---|
| |
| Used with: | sandpaper - 93 × 185 mm (hook and loop) or 93 × 230 mm (plain, clamped) |
| Access Requirements: | Handheld Sander Introduction |
| Manual: | ManualsLib |
| Tutors: | Lukas NitramLegov Pakue Lmnl99 Johannes Luzian Keno Sebastian Jakob |
The Bosch PSS 250 AE can be used with hook-and-loop sandpaper strips, but regular ones can also be clamped in.
It has a "microfilter" that reduces airborne dust, but you should ideally use a shop vac (will fit in combination with the rubber adapter in the sander's case) and/or go outside and it does not hurt to still protect yourself with a dust mask. The sandpaper should have the appropriate holes for dust extraction to work, of course!
SKIL 7210 "Fox 2in1"
| MachineInfoBox SKIL 7210 "Fox 2in1" | |
|---|---|
| |
| Used with: | sandpaper - 93 × 185 mm (hook and loop) |
| Access Requirements: | Handheld Sander Introduction |
| Manual: | skil.de |
| Tutors: | Lukas NitramLegov Pakue Lmnl99 Johannes Luzian Keno Sebastian Jakob |
The SKIL 7210 is a "multi" sander that can also be equipped with a delta sander-like tip - unfortunately, that part is not included with the one we have.
This sander can only be used outside and with a dust mask at the moment, its bag only traps the relatively large dust particles! Perhaps this could be improved with a custom shop vac adapter.
