User:Luzian/Foam Cutter: Difference between revisions
From CoMakingSpace Wiki
NitramLegov (talk | contribs) m Remove type (to remove it from tool overview - we might need a better solution here) |
NitramLegov (talk | contribs) m No Commissioning |
||
| Line 12: | Line 12: | ||
[[User:Luzian|Luzian]] built one out of thin metal tube, special wires and a handle with a button to control the power! | [[User:Luzian|Luzian]] built one out of thin metal tube, special wires and a handle with a button to control the power! | ||
== Use == | == Use == | ||
Latest revision as of 11:28, 21 March 2025
| MachineInfoBox Foam Cutter | |
|---|---|
| |
| Synonyms: | hot wire cutter; DE: Heißdrahtschneider |
| Material: | foam |
| Access Requirements: | |
| Tutors: | |
A foam cutter uses a hot wire to slice through foam. It is perfect for any projects using foam (e.g. building model aircraft).
Luzian built one out of thin metal tube, special wires and a handle with a button to control the power!
Use
Connect the power cable to a regulated power supply. Adjust the voltage to 3-6 V and limit the current to a maximum of 1.25 A (4 V/0.8 A works pretty well and increases the wire lifespan). Plug the power cable into the foam cutter and switch the power on. Now you are good to go. If you press the red button on the foam cutter the wire will heat up instantly.
Caution
- don't touch the wire during operation
- don't use more than 6 V
- don't let children use the foam cutter without supervision
Wires
The foam cutter uses 70 mm StarTec ST 10659 wires. They are wear parts and can tear. New ones are available (for example) at ersa Distribution.
