Punches: Difference between revisions
(→Drift Punches: aka, location, other variants) |
(→Center Punches: location) |
||
Line 8: | Line 8: | ||
|type=hand tool | |type=hand tool | ||
|access=upon reading | |access=upon reading | ||
|location= | |location=above [[Drilling Table|drilling table]] | ||
|material=[[metal]], [[wood]], [[plastic]] | |material=[[metal]], [[wood]], [[plastic]] | ||
|used with=[[hammers]] | |used with=[[hammers]] | ||
}} | }} | ||
If you want to mark something harder than the listed materials such as [[stone]] or [[Material:Concrete|concrete]], just use a cheap [[Nails|nail]] instead of this tool! | If you want to mark something harder than the listed materials (such as [[stone]] or [[Material:Concrete|concrete]]), just use a cheap [[Nails|nail]] instead of this tool! | ||
Can be re-sharpened on a [[Bench Grinder|bench grinder]]. | |||
<br clear=all> | <br clear=all> |
Revision as of 16:57, 19 December 2017
Punches are small tools driven with a hammer, e.g. in order to leave a mark or a hole.
Center Punches
ToolInfoBox Center Punch | |
---|---|
Synonyms: | DE: Körner |
Type: | hand tool |
Material: | metal, wood, plastic |
Used with: | hammers |
Location: | above drilling table |
Access Requirements: | upon reading |
If you want to mark something harder than the listed materials (such as stone or concrete), just use a cheap nail instead of this tool!
Can be re-sharpened on a bench grinder.
Hole Punches
ToolInfoBox Hole Punches | |
---|---|
Synonyms: | leather punches; DE: Locheisen, Ausschlageisen, Stanzeisen |
Type: | hand tool |
Material: | fabric, leather, paper, foam rubber |
Used with: | hammers |
Access Requirements: | upon reading |
Similar (More or Less): | punch pliers |
For smaller holes, see punch pliers. For the common office tool, see two-hole punch.
As seen towards the end of a very interesting lamp build on YouTube, chucking a hole punch into a drill may actually work pretty well to cut wooden plugs (verification needed)!
Available sizes:
- 2.5 mm
- 3 mm
- 4 mm
- 5 mm
- 6 mm
- 7 mm
- 8 mm
- 9 mm
- 10 mm
Drift Punches
ToolInfoBox Drift Punch | |
---|---|
Synonyms: | DE: Durchtreiber, Nageltreiber, Durchschlag |
Type: | hand tool |
Material: | nails |
Used with: | hammers |
Location: | above drilling table |
Access Requirements: | upon reading |
Similar (More or Less): | pin punch |
Use this punch to align drilled pieces, e.g. for riveting, or to drive nails in a little deeper without leaving ugly hammer marks. There are also varieties with a cupped end for the nail head to disappear into, but we just have a simple straight one.
Also useful for removing nail fragments from scrap wood!