Prusa i3 MK2S (1): Difference between revisions
From CoMakingSpace Wiki
NitramLegov (talk | contribs) m (Remove extra set of proerties) |
NitramLegov (talk | contribs) m (→Prusa i3 MK2S) |
||
| Line 1: | Line 1: | ||
== Prusa i3 MK2S == | == Prusa i3 MK2S == | ||
Revision as of 22:44, 24 October 2022
Prusa i3 MK2S
| MachineInfoBox Original Prusa i3 MK2S | |
|---|---|
| |
| Synonyms: | Prusa i3 MK2 (nearly identical) |
| Material: | plastic filament |
| Access Requirements: | 3D Printer Introduction |
| Firmware: | https://www.prusa3d.com/drivers/ |
| Software: | Slic3r Prusa Edition |
| Manual: | prusa3d.com |
| Tutors: | Lukas NitramLegov Pakue Mitja Lmnl99 Johannes Ciaran Luzian Leo Narquadah Kalunho Björn |
The Prusa i3 MK2S is our default 3D printer. We have five of them, named "P1" through "P5". Please note that P1 has received an upgrade and now has a magnetic board.
In addition to receiving a personal introduction from one of the tutors, make sure that you have read the handbook and use the latest version of Slic3r available at the drivers and manuals page.
The build volume of this model is 250 × 210 × 200 mm.
