Project:Disc Sander: Difference between revisions
From CoMakingSpace Wiki
(linked issue, size considerations) |
(speed, cleaning) |
||
| Line 6: | Line 6: | ||
|synonyms=disk sander; DE: Tellerschleifer, Schleifteller | |synonyms=disk sander; DE: Tellerschleifer, Schleifteller | ||
|type= | |type= | ||
|status=under construction | |||
|material=[[wood]] | |material=[[wood]] | ||
|used with= | |used with= | ||
| Line 20: | Line 21: | ||
* find out which maximum size would fit on the lathe - '''320 mm''' according to its wiki page | * find out which maximum size would fit on the lathe - '''320 mm''' according to its wiki page | ||
* find out which sizes of sanding discs (''Schleifscheiben'') are common and affordable in that range - '''250 mm''' (approx. 10") looks good | * find out which sizes of sanding discs (''Schleifscheiben'') are common and affordable in that range - '''250 mm''' (approx. 10") looks good | ||
* '''make''' or get a faceplate for the lathe | * '''make''' or get a faceplate for the lathe (in progress) | ||
* apply velcro disc | |||
* start sanding | |||
== Speed == | |||
[https://www.proxxon.com/de/micromot/28060.php Comparable tools] are run with speeds between 250 and 750 m/min. Therefore, only the lowest speed of the lathe should be used to drive the sanding disc (850 rpm -> approx. 667 m/min at the edge). | |||
== Cleaning == | |||
Sandpaper can be restored a few times before it is used up by briefly sanding a piece of rubber! Instead of proper [https://www.holz-metall.info/shop1/artikel8086.htm cleaning sticks] you can apparently get great results [https://www.operation-eigenheim.de/schleifpapier-reinigen-mit-alten-schuhen/ with the sole of an old shoe] - any donors? ;-) | |||
Revision as of 16:24, 23 May 2019
This is a wish list page - we don't have this tool yet!
| ToolInfoBox Disc Sander | |
|---|---|
| |
| Synonyms: | disk sander; DE: Tellerschleifer, Schleifteller |
| Status: | under construction |
| Material: | wood |
Lukas will try to build a disc sander that is driven by the "Güde 1000" wood lathe! It should not be that hard to do but the awkward work angle may be a disadvantage.
Important preparations:
- find out which maximum size would fit on the lathe - 320 mm according to its wiki page
- find out which sizes of sanding discs (Schleifscheiben) are common and affordable in that range - 250 mm (approx. 10") looks good
- make or get a faceplate for the lathe (in progress)
- apply velcro disc
- start sanding
Speed
Comparable tools are run with speeds between 250 and 750 m/min. Therefore, only the lowest speed of the lathe should be used to drive the sanding disc (850 rpm -> approx. 667 m/min at the edge).
Cleaning
Sandpaper can be restored a few times before it is used up by briefly sanding a piece of rubber! Instead of proper cleaning sticks you can apparently get great results with the sole of an old shoe - any donors? ;-)
