ZJ5116 TB 16: Difference between revisions
From CoMakingSpace Wiki
NitramLegov (talk | contribs) m (Formatting) |
NitramLegov (talk | contribs) m (→ZJ5116 TB 16: Add assetid) |
||
| Line 8: | Line 8: | ||
|location=[[Location::Drilling Table|drilling table]] | |location=[[Location::Drilling Table|drilling table]] | ||
|manual= | |manual= | ||
}} | |assetid=83}} | ||
* Drill bit sizes: 1-16mm (neues Futter) | * Drill bit sizes: 1-16mm (neues Futter) | ||
Revision as of 14:02, 5 November 2022
ZJ5116 TB 16
| MachineInfoBox ZJ5116 TB 16 | |
|---|---|
| |
| Type: | Drill Presses |
| Location: | Drilling Table |
| Access Requirements: | Drill Introduction |
| Status: | Working |
| Tutors: | Lukas NitramLegov Pakue Lmnl99 Johannes Luzian Keno Jakob |
- Drill bit sizes: 1-16mm (neues Futter)
- Transmission: 16 gear (170-3080rpm)
According to the sign on the machine and this document, the machine has the following (relevant) specs:
| Specification | Value |
|---|---|
| Motor Power | 550 W |
| Spindle Travel | 85 mm |
| U/min | 170-3080 |
| Spindle Taper | MT2 |
| Table size | 290 mm × 290 mm |
