Bolt Cutter: Difference between revisions
NitramLegov (talk | contribs) m (image) |
m (German name) |
||
(2 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
{{ToolInfoBox | {{ToolInfoBox | ||
|tool name=Bolt Cutter | |tool name=Bolt Cutter | ||
|german=Bolzenschneider | |||
|image=Bolt Cutter.jpg | |image=Bolt Cutter.jpg | ||
|synonyms=DE: Bolzenschneider | |synonyms=DE: Bolzenschneider | ||
Line 6: | Line 7: | ||
|material=[[metal]] rods (up to 8 mm Ø) | |material=[[metal]] rods (up to 8 mm Ø) | ||
|used with= | |used with= | ||
|location=[[Metal Workshop|metal workshop]] | |location=[[Location::Metal Workshop|metal workshop]] | ||
|access= | |access=read this page | ||
|manual= | |manual= | ||
|donation= | |donation= | ||
Line 25: | Line 26: | ||
[[Category:Metalworking]] | [[Category:Metalworking]] |
Latest revision as of 23:33, 21 February 2022
ToolInfoBox Bolt Cutter | |
---|---|
Synonyms: | DE: Bolzenschneider |
Type: | hand tool |
Material: | metal rods (up to 8 mm Ø) |
Location: | metal workshop |
Access Requirements: | read this page |
Similar (More or Less): | diagonal pliers |
A bolt cutter is used to cut metal rods or chains quickly and can handle thicker stock than other "cutting pliers".
You shouldn't use it for threaded rods, metric screws or other parts where you would want a nice and clean cut, but it's very handy for shortening wood screws! Just make sure you tap the holes with an intact screw prior to inserting the cut ones or you will have a hard time getting them in there.
Safety
Be aware of flying parts! Protect yourself and others, especially when cutting off just a little bit as that will most likely be propelled through half the room.
Side note: bolt cutters are often used for the wrong reasons and are commonly viewed as a "break-in tool" - just be aware of that when sporting one in public...
Sharpening
The tool has to be disassembled prior to sharpening and is re-adjusted upon assembly, more details once we have more experience with this!