Bandsaw Fence: Difference between revisions
From CoMakingSpace Wiki
Created page with "{{ToolInfoBox |tool name=Simple Straight Fence |image=simple bandsaw fence.jpg |synonyms=parallel fence; DE: Bandsägen-Parallelanschlag |type=jig |status= |material= |use..." |
(No difference)
|
Revision as of 01:13, 5 September 2019
| ToolInfoBox Simple Straight Fence | |
|---|---|
| |
| Synonyms: | parallel fence; DE: Bandsägen-Parallelanschlag |
| Type: | jig |
| Used with: | Metabo BS 1638 W |
| Location: | wood workshop (above bandsaw) |
| Access Requirements: | read this page |
| Tutors: | Lukas |
This bandsaw fence (made by Manu) looks similar to a parallel (or "rip") fence on the table saw. It is attached to the bandsaw's table with two small clamps.
However, you may need to use it at a slight angle depending on the sawband! If the blade drifts, a parallel fence will only cause you trouble... Determine the correct angle by freehanding a cut along a straight line for a few cm, then set the fence according to your workpiece!
