Holzmann D 460F: Difference between revisions
From CoMakingSpace Wiki
NitramLegov (talk | contribs) m (→Holzmann D 460F: more precise location) |
NitramLegov (talk | contribs) m (remove extrabox) |
||
| Line 4: | Line 4: | ||
|image=Holzmann D460F.jpg | |image=Holzmann D460F.jpg | ||
|type=Wood Lathe | |type=Wood Lathe | ||
|german=Drechselbank | |||
|material=[[Woodturning Blanks|woodturning blanks]] | |material=[[Woodturning Blanks|woodturning blanks]] | ||
|location=[[Location::Woodturning Area|woodturning area]] | |location=[[Location::Woodturning Area|woodturning area]] | ||
| Line 9: | Line 10: | ||
|manual=''[http://download.maschinenhandel-gronau.de/MANUAL_D_460_460F_DE.pdf maschinenhandel-gronau.de (DE)]'' | |manual=''[http://download.maschinenhandel-gronau.de/MANUAL_D_460_460F_DE.pdf maschinenhandel-gronau.de (DE)]'' | ||
|used with=[[Face Shield|face shield]], [[Woodturning Tools|woodturning tools]] | |used with=[[Face Shield|face shield]], [[Woodturning Tools|woodturning tools]] | ||
}} | |||
SAFETY NOTE: Make sure you lock the box with the on/off switch in place before use! DO NOT start the lathe when it can swivel, you may not be able to safely turn it off then and the belt/pulleys are exposed! | SAFETY NOTE: Make sure you lock the box with the on/off switch in place before use! DO NOT start the lathe when it can swivel, you may not be able to safely turn it off then and the belt/pulleys are exposed! | ||
| Line 35: | Line 36: | ||
{{#set: | {{#set: | ||
|Has caption=Wood Lathe | |Has caption=Wood Lathe | ||
}} | }} | ||
Revision as of 19:42, 19 October 2022
Holzmann D 460F
| MachineInfoBox Holzmann D 460F | |
|---|---|
| |
| Material: | woodturning blanks |
| Used with: | face shield, woodturning tools |
| Access Requirements: | Woodturning Introduction |
| Manual: | maschinenhandel-gronau.de (DE) |
| Tutors: | Lukas |
SAFETY NOTE: Make sure you lock the box with the on/off switch in place before use! DO NOT start the lathe when it can swivel, you may not be able to safely turn it off then and the belt/pulleys are exposed!
Specs
- max. workpiece diameter: 254 mm
- max. workpiece length: 450 mm
- spindle speeds: 650-3800 rpm (variable)
- motor: 370 W
- spindle thread: M33
- workholding options:
- headstock: four-jaw chuck
- tailstock: morse taper - accessories: rotating center, drill chuck
Speed Selection
The D 460F has an electronic speed selection which is regulated by a potentiometer (without scale!) above the on/off switch.
Upgrades/Improvements
Ideas:
- it would be nice to fix the control box more properly - this should be coordinated with Micha Ba. who is the machine's owner!
- get/make a faceplate and a drive center for more workholding flexibility
