Holzmann D 460F

From CoMakingSpace Wiki

Holzmann D 460F

MachineInfoBox

Holzmann D 460F

Holzmann D460F.jpg
Type: Wood Lathe
Material: woodturning blanks
Used with: face shield, woodturning tools
Location: woodturning area
Access Requirements: Woodturning Introduction
Status: operational
Manual: maschinenhandel-gronau.de (DE)
Tutors: Lukas




SAFETY NOTE: Make sure you lock the box with the on/off switch in place before use! DO NOT start the lathe when it can swivel, you may not be able to safely turn it off then and the belt/pulleys are exposed!

Specs

this lathe can be used with a drill chuck!
  • max. workpiece diameter: 254 mm
  • max. workpiece length: 450 mm
  • spindle speeds: 650-3800 rpm (variable)
  • motor: 370 W
  • spindle thread: M33
  • workholding options:
    • headstock: four-jaw chuck
    • tailstock: morse taper - accessories: rotating center, drill chuck

Speed Selection

The D 460F has an electronic speed selection which is regulated by a potentiometer (without scale!) above the on/off switch.

Upgrades/Improvements

Ideas:

  • it would be nice to fix the control box more properly - this should be coordinated with Micha Ba. who is the machine's owner!
  • get/make a faceplate and a drive center for more workholding flexibility

Accessories

Click the photos below for more information!