Search results

This one sits on the X axis.

...Westfalia router table fence-X.JPG|thumb|right|200 px|don't mess with the "X"!]] ...cases (working with a parallel fence), you will not need the knob labeled "X", so please don't mess with it too much...the next user will thank you!

Let's take about 2{{x}}20 minutes before each plenum to show others whay we're working on! If you * [[User:Johannes|Johannes]] showed a 5{{x}}5{{x}}5 RGB LED cube and was able to get feedback from the others about some har

# Perform a homing cycle ($H). You might have to release the machine first ($X). # Use the manual controls to bring the machine to the X/Y origin of your job.

|platform=Windows, MacOS X 10.4 to 10.12, Linux, Solaris;<br>''or browser-based''

* spindle thread: M25{{x}}2 mm; internal No. 2 morse taper (MK2)

File:5 WorkpieceZeroXY.jpg|Move the tooltip to the X and Y position that you have set up as your origin in the CAM software. File:6 zeroXY.jpg|Zero the work coordinates for X and Y by pressing „X Axis Zero" and „Y Axis Zero" (1,2). You have now fully set-up the zero po

Let's take up to 2{{x}}20 minutes before each plenum to show others what we're working on! If you

Let's take up to 2{{x}}20 minutes before each plenum to show others what we're working on! If you ...ll we lose members because of the move/how many months can we survive with x fewer people?

Let's take up to 2{{x}}20 minutes before each plenum to show others what we're working on! If you

* worktable size: 60x90 cm (length x width), engraving a bit smaller

* X Axis [Range] 900.0 In order to do so, you can use the <code>X-</code>/<code>X+</code> and <code>Y-</code>/<code>Y+</code> buttons in LaserCut's control p

Let's take up to 2{{x}}20 minutes before each plenum to show others what we're working on! If you ...Bahnstadtfest; [[Lukas]] measured it the following day: internal area 103{{x}}64 cm (one open side where the mill can stick out by about 5 cm), looks

|platform=Windows, Mac OS X (64 bit only)

The drive shaft's thread is 1 1/8" x 12 TPI Whitworth.

We've made two 30{{x}}40 mm clamps - for bigger pieces, you may want to try [[Corner Clamping J

* loss of steps or drift along x-axis

** press the "X" button on the control panel (will reset the printer, everything freezes bu

* How to move the x and y motors by using the control panel

Let's take about 2{{x}}20 minutes before each plenum to show others what we're working on! If you