Laserscript LS6090

MachineInfoBox Laserscript LS6090

Synonyms:	DE: Laserschneider, "Lasercutter"
Material:	wood, glass, acrylic glass, ... (list of cuttable & engravable materials; list of only engravable materials)
Used with:	laser exhaust system, water chiller
Access Requirements:	Laser Cutter Introduction, Lasercutter-Einweisung
Software:	Lasercut 5.3
Manual:	printed copy at the machine
Tutors:	NitramLegov Pakue Lmnl99 Johannes Luzian Keno Utis Sebastian Kalunho Björn, NitramLegov Pakue Lmnl99 Johannes Luzian Keno Utis Sebastian Kalunho Björn

General Information

power: 80 Watt
worktable size: 60x90 cm (length x width), engraving a bit smaller
- Z axis (height): 23 cm

Cost

The tube and filters need to be replaced from time to time which will add up to several hundred €.

Therefore, an appropriate user contribution is 20 ct per minute which you should please throw into the obvious cash box immediately or in advance.

Machine Control

The machine itself is mainly operated by the control panel located on the right side of the machine:

Homing

When you turn on the machine, please press the "Datum" button in order to Home the machine. This is needed so that the machine knows where the laser is located after a restart. The laser will move to the upper right corner of the machine.

Moving the Laser

In order to move the laser to the starting point of your job, please ensure that you are in the main menu and no option is being highlighted. This can be achieved by pressing "ESC" until you see the following:

Movements are possible if nothing is highlighted

Now you can move the laser by pressing the directional buttons.

Jog Speed

In case the laser is moving too much or too little with each button press, please go to the jog set menu by using the following key combination: Menu --> Down --> Down --> Enter

In this menu, you can set the jog distance. Please confirm the new distance by pressing Enter.

Starting the Job

After uploading your job to the machine (see LaserCut_5.3#Uploading_your_Job for details), you can start the job by pressing "Start / Pause". The same button will also pause your job in between if needed.

Setting the Focus

In order to set the focus of the laser, please put your workpiece on the tray and put the focus finder (little black 3D printed thingy) on top of it. Now, move the laser above the focus finder and move the tray up (by pressing "up") until you can barely slide the focus finder through the gap. The focus is now set to the surface of your workpiece.

Troubleshooting

Laser keeps starting at the same (wrong) position

Sometimes, the starting point of the laser cutter gets set to a fixed position by accident.

While we are not yet entirely sure how this happens, here's how to fix it:

Make sure the laser cutter is in the following condition (press Esc until the File name gets a grey background):
Press ⏎ so that a new menu opens
Select "Cancel" and confirm with ⏎