Project:Pizza Peel
From CoMakingSpace Wiki
| ProjectInfoBox Simple Pizza Peels | |
|---|---|
| |
| Status: | 75 % done |
| Release Date: | June 2018 |
| Initiator: | Lukas |
| Materials Used: | multi-ply |
| Tools Used: | table saw, scroll saw, rasps, sandpaper |
| Approx. Cost: | 10 € |
I wanted to make two simple pizza peels out of birch multi-ply.
This was a nice chance to try spiral-toothed scroll saw blades as the boards required for this project would be too large for the saw if cut with regular blades.
Design
Based on a peel and stone that I already have and the box it should fit in, these are the desired measurements:
- thickness:
5 mm6 mm (was available at the Space) - handle: approx. 12 × 4 cm
- surface: approx. 35 × 30 cm (wider than long)
- front edge: chamfered for 12 mm
Make
- cut: table saw for width, scroll saw for handle & curved shoulders
- chamfer: used a rasp to remove most of the unwanted material at the front edge
- sand: old sanding disc for cleaning up the cut, sanding block to finish the chamfer
--> only finished one so far, perhaps the chamfer needs to be adjusted due to the thicker material that was used - to be continued after some test pizzas
