Holzmann D 460F

MachineInfoBox Holzmann D 460F

Type:	Wood Lathes
Material:	woodturning blanks
Used with:	face shield, woodturning tools
Location:	Woodturning Area
Access Requirements:	Woodturning Introduction
Status:	Working
Manual:	maschinenhandel-gronau.de (DE)
Tutors:	Lukas

SAFETY NOTE: Make sure you lock the box with the on/off switch in place before use! DO NOT start the lathe when it can swivel, you may not be able to safely turn it off then and the belt/pulleys are exposed!

Specs

this lathe can be used with a drill chuck!

max. workpiece diameter: 254 mm
max. workpiece length: 450 mm
spindle speeds: 650-3800 rpm (variable)
motor: 370 W
spindle thread: M33
workholding options:
- headstock: four-jaw chuck
- tailstock: morse taper - accessories: rotating center, drill chuck

Speed Selection

The D 460F has an electronic speed selection which is regulated by a potentiometer (without scale!) above the on/off switch.

Upgrades/Improvements

Ideas:

it would be nice to fix the control box more properly - this should be coordinated with Micha Ba. who is the machine's owner!
get/make a faceplate and a drive center for more workholding flexibility

Accessories

Click the photos below for more information!

Four-Jaw Chucks