CMI C-S-BS 250: Difference between revisions
From CoMakingSpace Wiki
m (Has caption: testing if PAGENAME from InfoBox rule can be overwritten by #set (for galleries)) |
m (Has caption: testing whether first value in alphabet is displayed in galleries) |
||
| Line 30: | Line 30: | ||
{{#set: | {{#set: | ||
Machinetype=Bandsaw | Machinetype=Bandsaw | ||
|Has caption=Metal Bandsaw | |Has caption=a Metal Bandsaw | ||
}} | }} | ||
Revision as of 01:57, 5 February 2022
CMI C-S-BS 250
| MachineInfoBox CMI C-S-BS 250 | |
|---|---|
| |
| Synonyms: | CMI C-BAN-250 (probably the same); DE: "Metall-Bandsäge" |
| Material: | metal (depending on blade); wood (currently not intended) |
| Used with: | 1400 mm bandsaw blades |
| Access Requirements: | |
| Manual: | nearly identical: Westfalia RBS 205 |
| Tutors: | |
| Similar (More or Less): | scroll saw |
[[Has caption::power saw| ]]
This small bandsaw does not have much power, but is nice for learning the basics and in case you just need to make some curvy or cold cuts through soft metals.
The blade guides are very simple, just consisting of two pins for the sides and a bearing for the back of the blade. Ignaz is going to turn an eccentric bearing mount to increase their lifetime (by default, the blade runs too close to the center of the bearing).
Please refer to the proper blade-guide distances explained in our bandsaw introduction, NOT the ones from the manual!
Specs:
- blade length - 1400 mm
- max. blade width - ???
- max. blade thickness - 0.36 mm [1]
- max. cutting depth - 80 mm
