Router Table

This tool is not ready for use yet since not all commissioning steps have been completed. The process is also tracked on GitHub. Feel free to contribute to making it usable, any help is very welcome!

Task	comment	Status
Name the tool:	Router Table/Westfalia Universal Frästisch Nr. 64 56 97	done
Take a picture	-	done
Find the manual as PDF	See infobox	done
Documentation	For the moment only the Kingcraft Router is compatible.	done
Print QR-Code	use the wikicrawler	pending
Introduction	added to Handheld Router Introduction	done
Security Check	Are all fences included? We should add a clear mark for the feed direction & make push blocks. Martin: We should also add an emergency stop which can be triggered using a foot similar to what the Table Saw has.	pending
Test	Martin: It was tested together with Lukas and worked fine. Lukas should set this to done.	pending
tool's name, owner and approx. value	Owned by Martin, data provided to Lukas with the Dauerleihgabe Form.	done
Last step: make it available	physically and in the wiki - then delete this template	pending

ToolInfoBox Westfalia Universal Frästisch Nr. 64 56 97
Synonyms:	DE: Frästisch, Oberfrästisch
Type:	tool mount
Material:	wood
Used with:	routers, push blocks
Access Requirements:	upon introduction
Manual:	Westfalia

A router table turns a handheld router into a stationary tool. The router gets attached to the router table upside down in order to enable the workpiece to be fed through the router (as of this, it is for a router what a table saw is for a circular saw).

It is very important to realize that the exposed router bit is not only dangerous because of its sharp edges, but also because it can rip the workpiece out of your hand and let it fly across the workshop. ONLY feed workpieces through from the right to the left side so you are in control and not the router!

Please also see Project:Router Table in case you are planning to build your own.

Compatible Routers

• KingCraft KBF-1050E (loaned from Martin)

More to be determined...