Project:Pizza Peel: Difference between revisions
From CoMakingSpace Wiki
(one made, pictures and second one next) |
(added photos) |
||
| Line 1: | Line 1: | ||
{{ProjectInfoBox | {{ProjectInfoBox | ||
|project title=Simple Pizza Peels | |project title=Simple Pizza Peels | ||
|image= | |image=pizzapeel-0.JPG | ||
|status=75 % done | |status=75 % done | ||
|date=June 2018 | |date=June 2018 | ||
| Line 27: | Line 27: | ||
# sand: old [[Sanding Discs|sanding disc]] for cleaning up the cut, [[Sanding Block|sanding block]] to finish the chamfer | # sand: old [[Sanding Discs|sanding disc]] for cleaning up the cut, [[Sanding Block|sanding block]] to finish the chamfer | ||
→ only finished one so far, perhaps the chamfer needs to be adjusted due to the thicker material that was used - to be continued after some test pizzas | |||
<gallery mode=packed-hover heights=250 caption="major steps"> | |||
File: pizzapeel-1.JPG|transferring the design | |||
File: pizzapeel-2.JPG|cutting on the [[Scroll Saw|scroll saw]] | |||
File: pizzapeel-3.JPG|all cut out | |||
File: pizzapeel-4.JPG|smoothing the edges with an old [[Sanding Disc|sanding disc]] | |||
File: pizzapeel-5.JPG|a [[rasp]] forms the chamfer... | |||
File: pizzapeel-6.JPG|...and a [[Sanding Block|sanding block]] smooths it out | |||
File: pizzapeel-0.JPG|(probably) finished piece | |||
</gallery> | |||
[[Category:Quick Projects]] | [[Category:Quick Projects]] | ||
[[Category:Woodworking]] | [[Category:Woodworking]] | ||
Revision as of 17:46, 5 July 2018
| ProjectInfoBox Simple Pizza Peels | |
|---|---|
| |
| Status: | 75 % done |
| Release Date: | June 2018 |
| Initiator: | Lukas |
| Materials Used: | multi-ply |
| Tools Used: | table saw, scroll saw, rasps, sandpaper |
| Approx. Cost: | 10 € |
I wanted to make two simple pizza peels out of birch multi-ply.
This was a nice chance to try spiral-toothed scroll saw blades as the boards required for this project would be too large for the saw if cut with regular blades.
Design
Based on a peel and stone that I already have and the box it should fit in, these are the desired measurements:
- thickness:
5 mm6 mm (was available at the Space) - handle: approx. 12 × 4 cm
- surface: approx. 35 × 30 cm (wider than long)
- front edge: chamfered for 12 mm
Make
- cut: table saw for width, scroll saw for handle & curved shoulders
- chamfer: used a rasp to remove most of the unwanted material at the front edge
- sand: old sanding disc for cleaning up the cut, sanding block to finish the chamfer
→ only finished one so far, perhaps the chamfer needs to be adjusted due to the thicker material that was used - to be continued after some test pizzas
- major steps
transferring the design
cutting on the scroll saw
all cut out
smoothing the edges with an old sanding disc
a rasp forms the chamfer...
...and a sanding block smooths it out
(probably) finished piece
