Inclinometer: Difference between revisions
From CoMakingSpace Wiki
m (Location:: for SMW (hopefully correct from tomorrow on...)) |
(updated location, turn off after use!) |
||
| Line 2: | Line 2: | ||
|tool name=Inclinometer | |tool name=Inclinometer | ||
|image= | |image= | ||
|synonyms=level box, bevel box, digital protractor;<br>DE: Neigungsmesser, Neigungssensor, digitale Wasserwaage | |synonyms=level box, bevel box, digital protractor;<br>DE: Neigungsmesser, Neigungssensor,<br>digitale Wasserwaage | ||
|type=[[measuring]] tool | |type=[[measuring]] tool | ||
|status=in transit | |status=in transit | ||
|material= | |material= | ||
|used with=[[Table Saw|table saw]], [[Chop Saw|chop saw]] | |used with=[[Table Saw|table saw]], [[Chop Saw|chop saw]] | ||
|location= | |location=[[Location::Wood Workshop|wood workshop]] (above marking & measuring shelf) | ||
|access= | |access=read this page | ||
|tutors= | |tutors= | ||
|manual= | |manual= | ||
| Line 18: | Line 18: | ||
To use, simply reference the saw's table as "zero", then let the tool snap to the side of the blade and adjust the vertical bevel until you're happy. | To use, simply reference the saw's table as "zero", then let the tool snap to the side of the blade and adjust the vertical bevel until you're happy. | ||
Before you put the inclinometer back into its box, make sure to '''turn it off by holding the ON/OFF/REF button for a few seconds.''' | |||
[[Category: | [[Category:Marking & Measuring]] | ||
Revision as of 19:20, 26 June 2019
| ToolInfoBox Inclinometer | |
|---|---|
| |
| Synonyms: | level box, bevel box, digital protractor; DE: Neigungsmesser, Neigungssensor, digitale Wasserwaage |
| Type: | measuring tool |
| Status: | in transit |
| Used with: | table saw, chop saw |
| Location: | wood workshop (above marking & measuring shelf) |
| Access Requirements: | read this page |
| Similar (More or Less): | squares, levels |
This digital inclinometer with a magnetic base is an awesome helper for adjusting circular saw blades to a precise angle! Lukas will soon share this one on the marking & measuring shelf in the wood workshop.
To use, simply reference the saw's table as "zero", then let the tool snap to the side of the blade and adjust the vertical bevel until you're happy.
Before you put the inclinometer back into its box, make sure to turn it off by holding the ON/OFF/REF button for a few seconds.
