Sheet Sanders
ToolInfoBox Sheet Sanders | |
---|---|
Synonyms: | orbital finishing sanders; DE: Schwingschleifer, Rutscher |
Type: | power sanders |
Material: | depends on sanding sheet (usually wood) |
Used with: | sandpaper |
Location: | wood workshop |
Access Requirements: | after commissioning |
Similar (More or Less): | eccentric and other power sanders |
Sheet sanders have a square orbiting pad that lets you reach into corners and remove a similar amount of material as eccentric sanders. Because they lack the additional turning motion though, they are more prone to leaving sanding marks on your workpiece if you're not careful.
We should soon be able to add two sheet sanders to our sanding corner, they just need to be commissioned.
This tool is not ready for use yet since not all commissioning steps have been completed. The process is not yet tracked on GitHub. Feel free to contribute to making it usable, any help is very welcome!
Task | comment | Status |
---|---|---|
Name the tool: | Bosch PSS 250 AE; SKIL 7210 "Fox 2in1" | done |
Take a picture | - | done |
Find the manual as PDF | Bosch, SKIL | done |
Documentation | e.g. sheet sizes? method of sheet holding? dust collection? | good enough as a start |
Print QR-Code | use the wikicrawler | pending |
Introduction | Handheld Sander Introduction | done |
Security Check | Lukas | done |
Test | Bosch works well, SKIL should be improved with a shop vac adapter! | done |
tool's name, owner and approx. value | entered by Lukas | done |
Last step: make it available | physically and in the wiki - then delete this template | pending |
Bosch PSS 250 AE
ToolInfoBox Bosch PSS 250 AE | |
---|---|
Used with: | sandpaper - 93 × 185 mm (hook and loop) or 93 × 230 mm (plain, clamped) |
Location: | wood workshop |
Access Requirements: | after personal introduction |
Tutors: | Lukas |
Manual: | ManualsLib |
The Bosch PSS 250 AE can be used with hook-and-loop sandpaper strips, but regular ones can also be clamped in.
It has a "microfilter" that reduces airborne dust, but you should ideally use a shop vac (will fit in combination with the rubber adapter in the sander's case) and/or go outside and it does not hurt to still protect yourself with a dust mask. The sandpaper should have the appropriate holes for dust extraction to work, of course!
SKIL 7210 "Fox 2in1"
ToolInfoBox SKIL 7210 "Fox 2in1" | |
---|---|
Used with: | sandpaper - 93 × 185 mm (hook and loop) |
Location: | wood workshop |
Access Requirements: | after personal introduction |
Tutors: | Lukas |
Manual: | skil.de |
The SKIL 7210 is a "multi" sander that can also be equipped with a delta sander-like tip - unfortunately, that part is not included with the one we have.
This sander can only be used outside and with a dust mask at the moment, its bag only traps the relatively large dust particles! Perhaps this could be improved with a custom shop vac adapter.