3D Printers

From CoMakingSpace Wiki

Revision as of 20:50, 19 March 2018 by Lukas (talk | contribs) (more prominent photo)

Our 3D printer farm

This article is mandatory reading for anyone who would like to 3D print, but it does not replace a personal introduction!

All of our printers use "fused filament fabrication" (FFF, a.k.a. FDM) and are therefore limited to thermoplastics as materials. Lots of cool things can be made with this technology, but it's good to be aware of the limits of FFF before starting to design your parts.

You can find our 3D printer farm in the electronics room.

Available Printers

label type status
P1 Prusa i3 MK2S operational
P2 Prusa i3 MK2S operational
P3 Prusa i3 MK2S operational
P4 Prusa i3 MK2S operational
P5 Prusa i3 MK2S operational

General Usage Guidelines

Using the 3D printers, like any other machine, requires a personal introduction - ask a tutor to get one!

Slicing

A 3D model has to be virtually split into its layers ("sliced") before a printer can start building it up layer by layer in reality. You can use Slic3r Prusa Edition with the default settings for the MK2S (or MK2, doesn't matter) provided by Prusa Research.

Do Your Math

A few simple calculations will save you a lot of time and material:

  • shell thickness must be a multiple of the nozzle diameter
  • elements very close to or below the nozzle diameter won't turn out well
  • bottom/top thickness must be a multiple of your selected layer height

Supervision

  • even simple prints can go wrong, so please watch the homing process and the first layer closely and check the progress regularly
  • do not leave the printers unattended - you'll have to find someone else to supervise a print if you absolutely need to leave the building
  • there is no need to sit in front of the machine all the time, just do not leave the Space!

Cleanliness

  • for improved adhesion, remove any dust from the print bed and wipe it with a few drops of isopropanol
    • do not use acetone on the PEI sheet, it will destroy the print bed!
  • collect any clean plastic waste in the appropriate (material and color!)

SD Cards

  • if you don't know a file, don't print it - ideally, slice all your models just before printing

File Storage

  • always back up your files on your own storage, our SDs and computers might be cleaned up at any time without much warning!
  • do not use old G-codes over and over again, but rather save your STLs and slice freshly for every print - there could have been changes to the machine since your last visit!

Material Donations

We try to keep the cost low to allow anyone to print. Apart from the filament, we need new isopropanol from time to time.

Please donate for these expenses:

  • 5 ct/gram material cost
  • + any additional amount you like

Tutors

If you're not sure about something, these Makers might be able to help: