Drill Presses
From CoMakingSpace Wiki
| ToolInfoBox Einhell TB 13/5 ED | |
|---|---|
| |
| Synonyms: | bench drill, pillar drill; DE: Säulenbohrmaschine, "Tischbohrmaschine", "Bohrständer", "Senkbohrer" |
| Type: | power drill |
| Material: | depending on the drill bit: wood, plastic, metal |
| Access Requirements: | upon instruction |
| Similar (More or Less): | other drills |
To use the machine, you'll need to mount a drill bit that suits your workpiece and securely fasten it with the chuck key.
We got this machine when it was pretty old already so Patrick took it apart, cleaned and painted it. Something in the pulleys still isn't centered which causes slight vibration in the machine. It isn't much of an issue as the shaft is quite rigid and runs true. The drill bits can sometimes be a little off center as the chuck is not that great - just quickly check before drilling.
Safety
- read the manual!
- wear personal protection, but never operate the drill press with gloves on!
- don't drill materials with harmful dust!
- make sure there is nobody nearby who might be surprised by a piece of shrapnel flying their way!
- use a machine vise for small workpieces!
- never use a machine vise on top of a wooden board or two wooden boards at the same time (tower rule)!
Fastening Options
a lever clamp can be used for some workpieces such as this door handle shaft
- we should get one or two of these drill press locking clamps if they are available around here
- additional tables to mount on the simple "standard" one are probably worth the effort
- inspiration: Stephan Pöhnlein on YouTube
Jigs
- V-block for drilling into round or angled things
