This is the content required for an introduction to our reciprocating saw and jigsaws - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)
If you need this introduction, please reach out to the following tutors: Lukas, Patrick, Johannes, User:Luzian
Let's begin! First off, make sure you have read the corresponding tool's manual:
Safety
Personal protection: 
Additional protection for toxic or allergenic woods (especially hardwoods, e.g. beech and oak - see "dust") or for certain surface finishes or chemicals: 
| Dangers |
Precautions
|
| sharp oscillating blade - possible kickback |
- you MUST NOT turn on the saw when the blade is already touching something (e.g. the workpiece)
- you MUST let the baseplate touch the workpiece before starting to cut
- blind cut: leave the sawblade in the cut until it has stopped
- through cut: make sure the blade has stopped moving before putting the saw back on the table
- you MUST make sure the blade path is free and you won't cut into the table or similar
- you MUST make sure the blade is long enough so that it can reach through the material when fully retracted (too short a blade relative to the material being cut will cause dangerous kickback)
- you MUST make sure there are no obstacles such as nails in your path before starting a cut
- you MUST secure the workpiece with clamps so nothing shifts and nothing large falls down once the cut is made
|
| generates dust and small chips |
- you MUST wear goggles
- you SHOULD hook up the shop vac (and deactivate the "dust blow" function of the saw, if available)
- if your workpiece is contaminated with chemicals or made from hard woods like beech (Buche) or oak (Eiche), you SHOULD use a dust mask
|
| generates noise |
|
| no prevention of turning on after loss & restoration of power (keine Anlaufsicherung) |
- you MUST make sure the locking button is "off" before plugging the saw in (the trigger should move freely)
|
Demonstration
During the introduction, the tutor will show you the following:
- inserting/removing saw blades
- choosing and changing the pendulum or orbital action settings (Bosch PFZ 700 PE: chapter 7 in the manual)
Besides these safety notes, you should know which type of blade is suitable for the material you want to cut!
