Router Table Introduction

This is the content required for an introduction to our router table - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)

If you need this introduction, please reach out to the following tutors: Lukas, Martin, Keno, Patrick, Utis, Luzian

The handheld router introduction is required as a background for this introduction!

If you received that introduction before 2020-4-15, it still included the router table part and you only need to make sure you now watch both pages for updates. And as always: feel free to ask for a refresher whenever anything is not clear anymore!

proper feed directions for safe push cuts - click to see an animation!

a starting pin helps you make sure your workpiece stays in front of the router bit if you can't use a fence!

When working on a router table, additional care needs to be taken as the router is turned upside down in a fixed position!

• the workpiece can be grabbed and shot across the room if you attempt a climb cut, only do push cuts!
  • only feed from right to left when you work in front of the bit!
  • see schematic for other cases, but make sure you really understand what's going on
• keep all body parts at least a hand's width away from the exposed bit (use push blocks if that's not possible)
• use all possible fences, guards, featherboards etc. to secure the workpiece and reduce exposure of the bit
• make use of a starting pin (or similar) when working fenceless with a bearing bit ^{tip #6}

Demonstration

The tutor will show you in detail how to:

• Adjust and lock the height of the router
• Insert the bit into the router
• Tighten the collet (best through the top of the table)
• Turn the router on and off by using the safety switch of the router table
• How to properly store the fence together with all small parts so stuff does not get lost all the time!