Tyme Avon: Difference between revisions
From CoMakingSpace Wiki
m (→Tyme Avon: status -> #264) |
NitramLegov (talk | contribs) m (→Tyme Avon: more precise location) |
||
| Line 6: | Line 6: | ||
|type=Wood Lathe | |type=Wood Lathe | ||
|material=[[Woodturning Blanks|woodturning blanks]] | |material=[[Woodturning Blanks|woodturning blanks]] | ||
|location=[[Location:: | |location=[[Location::Woodturning Area|woodturning area]] | ||
|manual= | |manual= | ||
|status=accessories [https://github.com/comakingspace/do-something/issues/264 need documentation] | |status=accessories [https://github.com/comakingspace/do-something/issues/264 need documentation] | ||
Revision as of 19:48, 14 October 2022
Tyme Avon
| MachineInfoBox Tyme Avon ATL301 | |
|---|---|
| |
| Type: | Wood Lathes |
| Material: | woodturning blanks |
| Used with: | face shield, woodturning tools |
| Location: | Woodturning Area |
| Access Requirements: | Woodturning Introduction |
| Status: | Working |
| Tutors: | Lukas |
The Tyme Avon is an old, but solidly built lathe that has replaced our flimsy Güde 1000.
Specs
We seem to have the Model ATL301 with 36" (915 mm) between centers and a bed length of 52" (1320 mm).
- max. workpiece diameter (above bed): 280 mm (11")
- max. workpiece diameter (swiveled 90°): 495 mm (19.5")
- max. workpiece diameter (swiveled 180°): 610 mm (24")
- max. workpiece length: 900 mm
- spindle speeds: 470 - 750 - 1150 - 2000 rpm
- motor: 550 W (3/4 hp)
- spindle thread: M25 × 2 mm; internal No. 2 morse taper (MK2)
- workholding options:
- headstock: drive center, faceplate, four-jaw chuck, ...
- tailstock: No. 2 morse taper (MK2) - accessories: rotating centers, our "usual" drill chucks also fit
Speed Selection
The lathe can run at various speeds depending on which pulleys are connected by the belt:
Do not put excessive tension on the belt - you'll be very happy about the belt slipping in case you've made a mistake and the tool digs into the workpiece!
New belts are still sold at store.lathes.co.uk
