Taps and Dies: Difference between revisions
(→Taps: broken M3 tap) |
(→Taps: M2 now available) |
||
| Line 11: | Line 11: | ||
|synonyms=DE: Gewindebohrer,<br>"Innengewindeschneider" | |synonyms=DE: Gewindebohrer,<br>"Innengewindeschneider" | ||
|type=bit | |type=bit | ||
|access= | |access=upon reading | ||
|location= | |location=[[Metal Workshop|metal workshop]] | ||
|material=[[metal]], ''[[plastic]]'' | |material=[[metal]], ''[[plastic]]'' | ||
}} | }} | ||
| Line 19: | Line 19: | ||
Did you know? The proper drill bit size for common thread diameters can also be found on the back of the [[Calipers#Digital Caliper|digital caliper]]! | Did you know? The proper drill bit size for common thread diameters can also be found on the back of the [[Calipers#Digital Caliper|digital caliper]]! | ||
We've got a set of M3/4/5/6/8/10/12 three-stage taps. | We've got a set of M3/4/5/6/8/10/12 three-stage taps with holders. [[User:Lmnl99|Lmnl99]] also brought in an M2 tap which only works with our holders when a piece of tape is wrapped around the shaft. | ||
The rough M3 tap is broken. A new one should be there by the end of the week. | The rough M3 tap is broken. A new one should be there by the end of the week. | ||
Revision as of 17:48, 13 June 2018
Taps and dies are used to create or clean up threads, usually in metal.
Three-stage taps need to be used in the correct order (from rough to fine). You can tell the order by judging how complete the cutting edge is or by the rings around the shaft: 1 ring -> 2 rings -> no ring.
Here's a makezine tutorial on using taps and dies.
Taps
| ToolInfoBox Taps | |
|---|---|
| |
| Synonyms: | DE: Gewindebohrer, "Innengewindeschneider" |
| Type: | bit |
| Material: | metal, plastic |
| Location: | metal workshop |
| Access Requirements: | upon reading |
Taps can be ruined by incorrect use, please ask for help if you are new to them. Into anything harder than aluminum, they are driven by hand using a tap wrench (DE: Windeisen).
Did you know? The proper drill bit size for common thread diameters can also be found on the back of the digital caliper!
We've got a set of M3/4/5/6/8/10/12 three-stage taps with holders. Lmnl99 also brought in an M2 tap which only works with our holders when a piece of tape is wrapped around the shaft.
The rough M3 tap is broken. A new one should be there by the end of the week.
Dies
| ToolInfoBox Dies | |
|---|---|
|
| |
| Synonyms: | DE: Schneideisen, "Außengewindeschneider" |
| Material: | metal, plastic |
We have an assortment of dies of the following sizes:
| M3 |
| M4 |
| M5 |
| M6 |
| M8 |
| M10 |
| M12 |
