Material:Laser Marking Spray
From CoMakingSpace Wiki
There are special spray paints that you can apply to any blank metal surface and bond it permanently by engraving the desired spots with a laser cutter. Wherever the laser engraves, the spray will stay as a colored coating on the metal. Everywhere else the paint can easily be washed or wiped off.
We have tried spray paint for black markings (markSolid 114) but there are more options from the same brand, products by other manufacturers and even "hacks" involving cheap molybdenum dry lube.
Usage
Like any other spray paint, please use it outside out of courtesy to fellow breathing lifeforms and our tabletops.
- make sure your surface is absolutely dust and grease-free
- shake the spray can for at least one minute
- open the spray can and choose the black spray cap for small surfaces or the whitish one for larger surfaces
- apply an even coat of the spray paint, but not too thick!
- wait for the paint to dry, it turns into a light grey when fully dried
- engrave the part where you want the black coating (settings as if you want to cut, it needs a lot of heat!)
- wipe off the remaining paint carefully
MarkSolid 114
| MaterialInfoBox markSolid 114 | |
|---|---|
| |
| Synonyms: | black laser marking spray; DE: Laser-Markierspray |
| Suggested Tools: | |
| Used with: | laser cutter |
| Contains: | molybdenum trioxide |
Attention
- use high power settings to make the mark permanent (e.g. 100 % power, 5 % speed)
- markSolid 114 is very expensive, so please make sure to donate some extra bucks (it's about 70 €/can)
Gallery
-
sheet of aluminum, coated with markSolid 114
