Taps and Dies: Difference between revisions
(Created page with "Taps and dies are used to create or clean up threads, usually in metal. Three-stage taps need to be used in the correct order ('''from rough to fine'''). You can tell the...") |
(→Taps: broken M3 tap) |
||
| Line 20: | Line 20: | ||
We've got a set of M3/4/5/6/8/10/12 three-stage taps. | We've got a set of M3/4/5/6/8/10/12 three-stage taps. | ||
The rough M3 tap is broken. A new one should be there by the end of the week. | |||
<br clear=all> | <br clear=all> | ||
Revision as of 12:12, 11 April 2018
Taps and dies are used to create or clean up threads, usually in metal.
Three-stage taps need to be used in the correct order (from rough to fine). You can tell the order by judging how complete the cutting edge is or by the rings around the shaft: 1 ring -> 2 rings -> no ring.
Here's a makezine tutorial on using taps and dies.
Taps
| ToolInfoBox Taps | |
|---|---|
| |
| Synonyms: | DE: Gewindebohrer, "Innengewindeschneider" |
| Type: | bit |
| Material: | metal, plastic |
Taps can be ruined by incorrect use, please ask for help if you are new to them. Into anything harder than aluminum, they are driven by hand using a tap wrench (DE: Windeisen).
Did you know? The proper drill bit size for common thread diameters can also be found on the back of the digital caliper!
We've got a set of M3/4/5/6/8/10/12 three-stage taps.
The rough M3 tap is broken. A new one should be there by the end of the week.
Dies
| ToolInfoBox Dies | |
|---|---|
|
| |
| Synonyms: | DE: Schneideisen, "Außengewindeschneider" |
| Material: | metal, plastic |
We have an assortment of dies of the following sizes:
| M3 |
| M4 |
| M5 |
| M6 |
| M8 |
| M10 |
| M12 |
