Sliding Table Saw Introduction: Difference between revisions
(basic structure) |
|||
| Line 31: | Line 31: | ||
== Demonstration == | == Demonstration == | ||
The tutor will show you these steps in detail: | The tutor will show you these steps in detail: | ||
* how to use "[[Fritz & Franz]]" | |||
* how to set up the parallel fence | |||
* how to set up the miter/crosscut fence(?) | |||
* how to adjust blade height and angle (if angle is changed: return to exactly 90° by means of a [[square]] or [[inclinometer]]!) | |||
* practice cut(s) | |||
* <...> | * <...> | ||
[[Category:Introductions]] | [[Category:Introductions]] | ||
Revision as of 12:13, 20 January 2024
This page is INCOMPLETE and still missing some important information before it can be used as a resource. Please use the "Discussion" feature above or talk to one of the tutors if you would like to help improve it. Thanks!
This is the content required for an introduction to our Sliding Table Saw - reading this does NOT replace the mandatory session with a tutor! It will make it a lot quicker though ;-)
The table saw introduction is required as a baseline before you can receive this introduction!
If you are ready for this introduction, please reach out to the following tutors: NAME-HERE
Let's begin! First off, make sure you have read the machine's wiki page and <MANUAL>.
Safety
| Dangers | Precautions |
|---|---|
| <danger 1> | <precaution 1> |
| <danger 2> | <precaution 2> [...] |
Suggested Reading
Besides these safety notes, you should read <...>
Helpful links:
Demonstration
The tutor will show you these steps in detail:
- how to use "Fritz & Franz"
- how to set up the parallel fence
- how to set up the miter/crosscut fence(?)
- how to adjust blade height and angle (if angle is changed: return to exactly 90° by means of a square or inclinometer!)
- practice cut(s)
- <...>
