Project:Door Panel Storage Solution for VW T5: Difference between revisions
From CoMakingSpace Wiki
m images added |
m redlinked laser joint |
||
| (6 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
'''Door Panel Storage for a Van''' | '''Door Panel Storage for a Van''' | ||
This project involves designing and constructing custom storage compartments for the side and door panels of a van. The storage compartments are made from 4 mm beech plywood and are precisely cut using a laser cutter. The design process is carried out in Onshape, utilizing features like Laser Joint and Auto Layout for efficient and accurate CAD modeling. The assembly is achieved using finger joints (Laser Joint) for a sturdy and seamless fit. | This project involves designing and constructing custom storage compartments for the side and door panels of a van. The storage compartments are made from 4 mm beech plywood and are precisely cut using a laser cutter. The design process is carried out in Onshape, utilizing features like Laser Joint and Auto Layout for efficient and accurate CAD modeling. The assembly is achieved using finger joints ([[Laser Joint|laser joint]]) for a sturdy and seamless fit. | ||
{{ProjectInfoBox | |||
|project title= Door Panel Storage for a Van | |||
|image=Sidepanel.jpg | |||
|status= finished | |||
|date= 10/2024 | |||
|initiator=[[Tom]] | |||
|team= | |||
|materials= 4 mm beech [[plywood]] | |||
|tools= [[Lasercutter]] | |||
|software= [[Onshape]], [https://www.cutlistoptimizer.com/ CutListOptimizer.com] | |||
|cost= 11€ per sheet of plywood (2 sheets) | |||
}} | |||
[[File:Onshape .png|thumb|Onshape CAD drawing using Laserjoint and Autolayout.]] | [[File:Onshape .png|thumb|Onshape CAD drawing using Laserjoint and Autolayout.]] | ||
[[File:Einzelteile.jpg|thumb|Sanding before assembly]] | [[File:Einzelteile.jpg|thumb|Sanding before assembly]] | ||
| Line 8: | Line 22: | ||
[[File:Front view.jpg|thumb|Sidepanel and sliding door panel. A rubber gasket was applied for protection]] | [[File:Front view.jpg|thumb|Sidepanel and sliding door panel. A rubber gasket was applied for protection]] | ||
[[File:Sidepanel.jpg|thumb|For installation the original panels and holders were used]] | [[File:Sidepanel.jpg|thumb|For installation the original panels and holders were used]] | ||
[[File:Sliding_door.jpg|thumb|Sliding door panel]] | |||
[[Category:Camping]] | |||
[[Category:Vehicles]] | |||
Latest revision as of 14:43, 12 February 2025
Door Panel Storage for a Van
This project involves designing and constructing custom storage compartments for the side and door panels of a van. The storage compartments are made from 4 mm beech plywood and are precisely cut using a laser cutter. The design process is carried out in Onshape, utilizing features like Laser Joint and Auto Layout for efficient and accurate CAD modeling. The assembly is achieved using finger joints (laser joint) for a sturdy and seamless fit.
| ProjectInfoBox Door Panel Storage for a Van | |
|---|---|
| |
| Status: | finished |
| Release Date: | 10/2024 |
| Initiator: | Tom |
| Materials Used: | 4 mm beech plywood |
| Tools Used: | Lasercutter |
| Software Used: | Onshape, CutListOptimizer.com |
| Approx. Cost: | 11€ per sheet of plywood (2 sheets) |
