Circle Router Jig: Difference between revisions
(→Circles: link for medium to small circles) |
(usage with a jigsaw) |
||
| Line 28: | Line 28: | ||
Then, make sure to '''[[clamp]] the jig down securely''' before starting your cut and you'll get great results! | Then, make sure to '''[[clamp]] the jig down securely''' before starting your cut and you'll get great results! | ||
[[File:router jig with jigsaw.JPG|thumb|right|200px|this router jig can also be used with a [[jigsaw]], but at least the corners won't turn out nearly as nice]] | |||
=== Future Improvements === | === Future Improvements === | ||
| Line 34: | Line 36: | ||
* the jig should be marked so potential users find this page ;-) | * the jig should be marked so potential users find this page ;-) | ||
<br clear=all> | |||
== Circles == | == Circles == | ||
''small circle jigs may be included with some routers, let's check and add them here!'' | ''small circle jigs may be included with some routers, let's check and add them here!'' | ||
Revision as of 21:57, 29 April 2020
When you're routing a hole or recess and want precision, freehanding is not an option. CNC routing may work, but takes a lot of preparation for a one-time cut - so your best option may be a router jig!
Rectangles
| ToolInfoBox Rectangle Router Jig | |
|---|---|
| |
| Synonyms: | adjustable rectangle routing template |
| Type: | guidance jig |
| Used with: | clamps, TX 30 key or screwdriver; router, copying rings (optional) |
| Location: | next to router table |
| Access Requirements: | read this page |
| Tutors: | Lukas |
We have some very handy flat aluminum extrusions that Lukas saved from the trash because of their jig potential: they can interlock with each other at 90 degrees at any length!
Before assembly, you will need to calculate the desired inside measurement. This depends on the way you'll use it:
- using a router within the jig:
inside(jig) = inside(hole/recess) + router base diameter - router bit diameter- advantages: maximum depth usable, clamps are not in the way of your movement
- disadvantage: large enough workpiece area needs to be availabe (easier with a palm router), router bases are usually not evenly round
- using a router with copying ring on top of the jig
- please double-check, not tested!
inside(jig) = inside(hole/recess) + copying ring diameter - router bit diameter - advantages: even guidance no matter how you turn the router, also works close to the workpiece's edge
- disadvantages: harder to clamp the jig down without obstructing the machine, loss of routable depth, only possible if copying ring is flatter than the jig
- please double-check, not tested!
Then, make sure to clamp the jig down securely before starting your cut and you'll get great results!
Future Improvements
- it would be very handy to keep a dedicated Torx key in the same place as the jig
- maybe we could add precise rulers for easier setup - e.g. glued on or engraved somehow?
- the jig should be marked so potential users find this page ;-)
Circles
small circle jigs may be included with some routers, let's check and add them here!
self-built options: look for "circle routing jig" or "Fräszirkel" online!
- tip by Wood Magazine on Instagram - advantages: circle size pretty much as small as you want, works with regular base plate/parallel guides, screw for fine tuning (M6: 1 mm/turn!)
